SEN-003 REVERSE PARKING AID
INSTALLATION INSTRUCTIONS
Congratulations on choosing the SEN-003 Reverse
Parking Aid for your vehicle. With correct installation
the sensor will provide years of trouble-free reverse
parking.
The sensor works by bouncing calibrated sound waves
off obstacles behind the vehicle. A digital display and
beeper informs the driver how close the rear bumper is
to impact.
To avoid distracting the driver while driving forwards,
the SEN-003 is active only when reverse gear is
engaged.
The digital display shows the approximate distance
between the rear bumper and the obstacle (in metres).
From a maximum distance of 2.0 metres down to 0.3
metres.
The display also shows two direction indicators which
will tell the driver whether the obstacle is located to the
left, right or middle of the rear bumper. More bars in
each indicator light up as the obstacle becomes closer.
The peizo buzzer inside the digital display provides
the audible feedback from the sensors. As the distance
reduces, the beeps from the buzzer become more
intense.
2.0 - 1.0 1 1
0.9 - 0.6 2 2
0.5 - 0.4 3 3
0.3 - 0.0 Constant 3
The SEN-003 control module generates the electronic
signals used by the sensor heads. The module has a
socket for each of the four sensors, one socket for
power and a socket for the digital display to plug in.
The control module can be mounted in the boot (near
reverse light power circuit).
The SEN-003 will provide much better coverage with
four heads rather then only two heads are used. All
heads must be plugged in and operational.
DIGITAL DISPLAY
CONTROL MODULE
Distance Beeps Bars
Digital display mounting
Front mounting digital display
The exact location for mounting the digital display
will vary across all vehicles. Follow these rules for
best result: -
Must be visible to driver.
Must not be in direct sunlight - excessive heat will
warp the plastic and destroy the electronics.
Must be kept totally moisture free and mostly dust
free.
The display comes with double sided tape; remove the
backing and stick firmly to mounting location. Ensure
the surface is free of oil, dust and moisture before
applying.
The digital display data cable is long enough to
traverse most passenger vehicles. The suggested
display location is in the middle of the rear parcel
shelf. The numbers displayed will appear reversed
when looking through the rear view mirror. It is
recommended for optimum safety considerations that
the driver is looking to the rear as reversing and thus
views the display located on the rear parcel shelf.
The display data cable plugs into the control module
via the “DS” socket.
Mounting the display at the front of the cabin may be
necessary in vehicles without rear parcel shelves
(station wagons, pickup trucks, 4WD’s and alike). It is
still recommended that the driver faces backwards
while reversing.
The control module should be mounted inside the boot
in a location where it will not suffer water or dust
ingressions. Ensure any luggage placed in the boot
cannot knock against the control module.
l
l
l
Control module mounting
DISPLAY LOOM
DIGITAL DISPLAY
CONTROL MODULE
R
R1
L1
L
Sensor & module location and effective fields.
Distance in metres.
Direction indicators.
Digital display layout.
Complete kit.
It is that these instructions are read
thoroughly prior to installation.
Check limitations, considerations & disclaimer.
essential
DYNAMCO PTY LTD
SECURING VEHICLES WORLDWIDE
AUSTRALIA WIDE INSTALLER HELPLINE 1800 811 815
SEN-003_INSTALL_COMPLETE.CDR, CREATED/UPDATED:29/08/2005.
(20 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais