Cisbo Parking sensor Manual do Utilizador descarregar pdf (Página 7)

1. To mash the

sensor heads, drill

two holes in

cardboard box that

the sensors are

supplied in. Use

the hole saw

supplied.

2. Insert the

sensor head

cables through the

box top and push

into place.

3. The box will

stop the over

spray from

contaminating the

sensor cables and

plugs.

4. Use a very

(very) fine grade

of wet and dry

abrasive paper to

remove the shine

of the heads.

5. Use PREPWASH

to remove any

grease, oil & dust.

Ensure the clean

surface is not

touched again until

after the painting

procedure is

complete. Solvent

fluid must be

enamel compatible.

6. Apply FLEXI-

PRIME plastic

adhesion

promoter. Two

light coats are

preferred to one

thick coat ***.

Leave in dust free

location to dry.

7. Apply lacquer

ground coat if

required - many

metallic paint

colours require

this extra coat to

cover the heads’

black colour. eg

GMH F146 needs

a “Golden Honey”

ground coat.

8. Apply coat(s) of

bumper colour.

Many thin coats

are preferred to

one thick coat.

9. Leave in a dust

free location to dry

between coats.

10. Ingredients

1. Prepwash

2. Primer coats(s)

3. Ground coat(s)

4. Final coat(s)

When completely

dried/hardened,

insert into vehicle

bumper.

TYPICAL COLOUR MATCHING/APPLICATION

*** Follow paint manufacturer’s safety and application instructions for best result.

DYNAMCO PTY LTD

SECURING VEHICLES WORLDWIDE

AUSTRALIA WIDE INSTALLER HELPLINE 1800 811 815

SEN-003_INSTALL_COMPLETE.CDR, CREATED/UPDATED:29/08/2005.

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Cisbo Parking sensor Manual do Utilizador Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Eletrónica para veículos motorizados Cisbo Parking sensor